Face Recognition & Temp. Detection Terminal

• Vanadium Oxide uncooled sensor measures a target's temperature
• Temperature Measurement Range: 86° to 113° F (30° to 45° C); accuracy: 0.1° C; deviation: ± 0.5° C
• Recognition Distance: 1 to 6 feet (0.3 to 1.8 m)
• Rapid Temperature Measurement Mode: Detects faces and temperatures without recording identities
• Authentication Modes Available: Card and temperature, face and temperature, card and face and temperature, etc.
• Face Mask Alert: If a face is detected without a mask, the device can deliver an audible voice reminder. At the same time, the authentication or attendance can then be validated.
• Mask Enforcement: If a face is detected without a mask, the device can deliver an audible voice reminder. Authentication or attendance can then be invalidated until a mask is detected.
• Temperature measurement results can be displayed on the authentication page.
• Voice prompts can be triggered when detecting abnormal temperatures.
• Door status (open/close) when detecting abnormal temperature can be configured.
• Transmits on- and offline temperature information to client software via TCP/IP communication and saves data on the client software.
• Face Recognition Duration: Less than 0.2 seconds per user; face recognition accuracy rate: ≥ 99%
• Capacities: 6,000 face images, 6,000 cards, and 100,000 events
• Recommended Height for Face Recognition: 4.5 to 6.2 feet (1.4 to 1.9 m)
• Supports 6 attendance statuses, including check in, check out, break in, break out, overtime in, overtime out
• Watchdog design and tamper-alert
• Audio prompt for authentication results
• NTP, manual time synchronization, and auto synchronization
• Connects to external access controller or Wiegand card reader via Wiegand protocol
• Connects to secure door control unit via RS-485 protocol to prevent door opening if terminal suffers vandalism
• Imports and exports data to the device from the client software

Notes:
*Biometric recognition products are not 100% resilient to spoofing. Elevated security requires multiple authentication modes.
*LTS recommends allowing 90 minutes for the device to acclimatize before use in order to get the most accurate temperature readings.